A San Diego and an Orange County man were killed in a Paragliding crash Saturday afternoon at the Gilderport in Torrey Pines, a lieutenant with the San Diego Fire-Rescue Department said.

The crash happened around 2:40 p.m. when the two men crashed and their gliders became entwined and fell around 75 feet onto the bluffs above Black’s Beach, Lt. Rich Stropsky said.

One was an experienced pilot and the other was getting an advanced certification, he said.

“Apparently what happened was the student individual was heading southbound and made a turn, a hard right turn right in this area where the flag is and ended up running into the other flyer that was in the northbound direction,” Stropky said.

Two Killed in Crash at Gliderport

[DGO] Two Killed in Crash at Gliderport

The two were not flying together, he said.

The more experienced of the two was a 61-year-old man from San Diego. The other man was identified as a 43-year-old man from  Orange County.

Rami Abuhamra was planning on hang gliding Saturday when he saw the crash. He said the ropes from both gliders became entwined and both gliders spiraled out of the control.

“They started spinning out and they went into the mountain,” he said.

The two were pronounced dead at the scene.

The recovery effort was especially challenging because of the terrain. Rescuers had to lower a first responder down to the victims via helicopter, Stropsky said.

The victims were at the bluff’s edge, caught on a knoll right at the edge of a vertical section of the cliff, he said.

Rescuers then pulled the bodies up by hand and carried the bodies off the cliff.

The San Diego County Medical Examiner’s Office will lead the investigation and determine the cause of death, Stropsky said.

The wind condition at the Gliderport was gusting around 9 mph that time of the crash, according to the National Weather Service.

Fatal paragliding accidents are relatively rare, Stropsky said. The last known fatal accident was in 2012, according to NBC 7 news archive.

Source link

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *